// CODE SNIPPET
1014.3.2.2 Inlet Pipe
Related Code Sections
1014.3.2.2 Traps and Interceptors, Inlet Pipe
Waste shall enter the interceptor through the inlet pipe ...
2018 Uniform Plumbing Code of Nevada > 10 Traps and Interceptors > 1014.0 Grease Interceptors > 1014.3 Gravity Grease Interceptors > 1014.3.2 Waste Discharge Requirements > 1014.3.2.2 Inlet Pipe
188.8.131.52 Systems Acceptance,
Piping between the exterior fire department connection and the check valve in the fire department inlet pipe shall be hydrostatically tested ...
Standard for the Installation of Sprinkler Systems 2016 of Nevada > 25 Systems Acceptance > 25.2 Acceptance Requirements > 25.2.1* Hydrostatic Tests > 184.108.40.206
H 501.7 Private Sewage Disposal Systems, Pipe Extension
The inlet and outlet pipe or baffle shall extend 4 inches (102 mm) above and not less than 12 inches (305 mm) below the water surface. The invert ...
2018 Uniform Plumbing Code of Nevada > H Private Sewage Disposal Systems > H 501.0 Septic Tank Construction > H 501.7 Pipe Extension
1016.3 Traps and Interceptors, Construction and Size
an interior baffle for full separation of the interceptor into two sections. The outlet pipe shall be the same size as the inlet pipe of the sand interceptor ...
2018 Uniform Plumbing Code of Nevada > 10 Traps and Interceptors > 1016.0 Sand Interceptors > 1016.3 Construction and Size
7.4.3 Service Water Heating, Service Hot-Water Piping Insulation
system . The first 8 ft of branch piping connecting to recirculated, heat-traced, or impedance heated piping . The inlet piping between ...
Energy Standard for Buildings Except Low-Rise Residential Buildings 2016 of Nevada > 7 Service Water Heating > 7.4 Mandatory Provisions > 7.4.3 Service Hot-Water Piping Insulation