// CODE SNIPPET
*§28-213.5.1 Increased Oversight
JUMP TO FULL CODE CHAPTER
At any site where a contractor that is included on the watch list created pursuant to section 28-213.5 performs work in an occupied building, the department shall perform one or more inspections in order to ensure compliance with applicable laws, rules, regulations and permitting requirements. The department may promulgate rules providing for additional oversight of such contractors where appropriate for the protection of the public.
*Section 28-213.5.1 was added by Local Law 155 of 2017. This law has an effective date of December 28, 2017.
*Section 28-213.5.1 was added by Local Law 155 of 2017. This law has an effective date of December 28, 2017.
Related Code Sections
*§28-213.5.1 Enforcement, Increased Oversight
and permitting requirements. The department may promulgate rules providing for additional oversight of such contractors where appropriate ...
NYC General Admin. Provisions 2014 > 2 Enforcement > 213 Penalty for Work Without a Permit > *§28-213.5 Watch List of Contractors Performing Work Without Required Permit > *§28-213.5.1 Increased Oversight
1605.3.1.1 Structural Design, Stress Increases
Increases in allowable stresses specified in the appropriate material chapter or the referenced standards shall not be used with the load ...
NYC Building Code 2014 > 16 Structural Design > 1605 Load Combinations > 1605.3 Load Combinations Using Allowable Stress Design > 1605.3.1 Basic Load Combinations > 1605.3.1.1 Stress Increases
1607.7.1.3 Structural Design, Stress Increase
for the loads specified in Section 1607.7.1, the allowable stress for the members and their attachments are permitted to be increased by one-third ...
NYC Building Code 2008 > 16 Structural Design > 1607 Live Loads > 1607.7 Loads on Handrails, Guards, Grab Bars, Seats and Vehicle Barrier > 1607.7.1 Handrail Assemblies and Guards > 1607.7.1.3 Stress Increase
503.10.3.5 Chimneys and Vents, Size Increase
Where the size of a vent connector is increased to overcome installation limitations and obtain connector capacity equal to the equipment input ...
NYC Fuel Gas Code 2008 > 5 Chimneys and Vents > 503 Venting of Equipment > 503.10 Vent Connectors for Category I Equipment > 503.10.3 Size of Vent Connector > 503.10.3.5 Size Increase
503.10.3.5 Chimneys and Vents, Size Increase
Where the size of a vent connector is increased to overcome installation limitations and obtain connector capacity equal to the appliance input ...
NYC Fuel Gas Code 2014 > 5 Chimneys and Vents > 503 Venting of Appliances > 503.10 Vent Connectors for Category I Appliances > 503.10.3 Size of Vent Connector > 503.10.3.5 Size Increase