// CODE SNIPPET
1810.4.8 Hollow-Stem Augered, Cast-In-Place Elements
JUMP TO FULL CODE CHAPTER
Where concrete or grout is placed by pumping through a hollow-stem auger, the auger shall be permitted to rotate in a clockwise direction during withdrawal. As the auger is withdrawn at a steady rate or in increments not to exceed 1 foot (305 mm), concreting or grouting pumping pressures shall be measured and maintained high enough at all times to offset hydrostatic and lateral earth pressures. Concrete or grout volumes shall be measured to ensure that the volume of concrete or grout placed in each element is equal to or greater than the theoretical volume of the hole created by the auger. Where the installation process of any element is interrupted or a loss of concreting or grouting pressure occurs, the element shall be redrilled to 5 feet (1524 mm) below the elevation of the tip of the auger when the installation was interrupted or concrete or grout pressure was lost and reformed. Augered cast-in-place elements shall not be installed within six diameters center to center of an element filled with concrete or grout less than 12 hours old, unless approved by the building official. If the concrete or grout level in any completed element drops due to installation of an adjacent element, the element shall be replaced.
Related Code Sections
1810.4.8 Soils and Foundations, Hollow-Stem Augered, Cast-In-Place Elements
Where concrete or grout is placed by pumping through a hollow-stem auger, the auger shall be permitted to rotate in a clockwise direction during ...
Building Code 2018 of Illinois > 18 Soils and Foundations > 1810 Deep Foundations > 1810.4 Installation > 1810.4.8 Hollow-Stem Augered, Cast-In-Place Elements
1705.8 Special Inspections and Tests, Cast-In-Place Deep Foundations
TABLE 1705.8 REQUIRED SPECIAL INSPECTIONS AND TESTS OF CAST-IN-PLACE DEEP FOUNDATION ELEMENTS TYPE CONTINUOUS SPECIAL INSPECTION ...
Building Code 2018 of Illinois > 17 Special Inspections and Tests > 1705 Required Special Inspections and Tests > 1705.8 Cast-In-Place Deep Foundations
7.1 One-Way Slabs, Scope
(b) Slabs cast on stay-in-place, noncomposite steel deck (c) Composite slabs of concrete elements constructed in separate placements but connected ...
7220.127.116.11 Fire and Smoke Protection Features, Cast-In-Place or Precast Walls
apply to plain, reinforced or prestressed concrete walls. TABLE 718.104.22.168 MINIMUM EQUIVALENT THICKNESS OF CAST-IN-PLACE OR PRECAST CONCRETE ...
Building Code 2018 of Illinois > 7 Fire and Smoke Protection Features > 722 Calculated Fire Resistance > 722.2 Concrete Assemblies > 722.2.1 Concrete Walls > 722.214.171.124 Cast-In-Place or Precast Walls
1810.4.7 Soils and Foundations, Enlarged Base Cast-In-Place Elements
Enlarged bases for cast-in-place deep foundation elements formed by compacting concrete or by driving a precast base shall be formed in or driven ...
Building Code 2018 of Illinois > 18 Soils and Foundations > 1810 Deep Foundations > 1810.4 Installation > 1810.4.7 Enlarged Base Cast-In-Place Elements