// CODE SNIPPET
3314.15.2 Hangers or Stirrups
Go To Full Code Chapter
Hangers or stirrups shall be of steel or wrought iron. Each such
hanger shall be formed to properly fit the platform and the hoist mechanism. The hanger or stirrup
shall be placed at least 6 inches (152 mm) but not more than 18 inches (457 mm) from the end of
the platform.
Exception:
Alternative spacing from the end of the platform may be utilized where the
manufacturer so specifies and such alternative spacing is indicated on design drawings
developed by a registered design professional.
Related Code Sections
3314.15.2 Safeguards During Construction or Demolition, Hangers or Stirrups
Hangers or stirrups shall be of steel or wrought iron. Each such hanger shall be formed to properly fit the platform and the hoist mechanism. The ...
3314.15.2 Safeguards During Construction or Demolition, Hangers or Stirrups
Hangers or stirrups shall be of steel or wrought iron. Each such hanger shall be formed to properly fit the platform and the hoist mechanism. The ...
3314.15.2 Safeguards During Construction or Demolition, Hangers or Stirrups
Hangers or stirrups shall be of steel or wrought iron. Each such
hanger shall be formed to properly fit the platform and the hoist mechanism. The ...
3314.15 Safeguards During Construction or Demolition, Two-Point Adjustable Suspended Scaffolds
or hanger that meets the requirements of Section 3315.15.2, and the platform shall be securely fastened thereto. Not more than two hangers or stirrups shall ...
25.7.1 Reinforcement Details, Stirrups
Stirrups shall extend as close to the compression and tension surfaces of the member as cover requirements and proximity of other reinforcement ...