UpCodes logo
Go To Full Code Chapter
1910.219(c)(2)(i)
All exposed parts of horizontal shafting seven (7) feet or less from floor or working platform, excepting runways used exclusively for oiling, or running adjustments, shall be protected by a stationary casing enclosing shafting completely or by a trough enclosing sides and top or sides and bottom of shafting as location requires.
1910.219(c)(2)(ii)
Shafting under bench machines shall be enclosed by a stationary casing, or by a trough at sides and top or sides and bottom, as location requires. The sides of the trough shall come within at least six (6) inches of the underside of table, or if shafting is located near floor within six (6) inches of floor. In every case the sides of trough shall extend at least two (2) inches beyond the shafting or protuberance.

Related Code Sections

1910.266(f)(8) Special Industries, Guarding
Each machine shall be equipped with guarding to protect employees from exposed moving elements, such as but not limited to, shafts, pulleys, belts ...
1910.219(c)(4) Machinery and Machine Guarding, Projecting Shaft Ends
Projecting shaft ends shall present a smooth edge and end and shall not project more than one-half the diameter of the shaft unless guarded ...
1910.211(f)(5) Machinery and Machine Guarding, Flywheels
Flywheels include flywheels, balance wheels, and flywheel pulleys mounted and revolving on crankshaft of engine or other shafting ...