// CODE SNIPPET
(A) Grounding of Supply Side of Class 2 Power Source
Related Code Sections
(A) Wiring Methods and Materials, Grounding of Supply Side of Class 2 Power Source
The supply side of the Class 2 power source shall be connected to an equipment grounding conductor in accordance with the applicable requirements ...
National Electrical Code 2020 of Minnesota > 3 Wiring Methods and Materials > 393 Low-Voltage Suspended Ceiling Power Distribution Systems > 393.60 Grounding > (A) Grounding of Supply Side of Class 2 Power Source
600.24 Special Equipment, Class 2 Power Sources
Metal parts of Class 2 power supplies and power sources shall be grounded by connecting ...
National Electrical Code 2020 of Minnesota > 6 Special Equipment > 600 Electric Signs and Outline Lighting > 600.24 Class 2 Power Sources
725.45 Special Conditions, Class 1 Circuit Overcurrent Device Location
of a single-phase, listed electronic power source, other than a transformer, having only a 2- wire (single-voltage) output for connection to Class 1 ...
National Electrical Code 2020 of Minnesota > 7 Special Conditions > 725 Class 1, Class 2, and Class 3 Remote- Control, Signaling, and Power-Limited Circuits > 725.45 Class 1 Circuit Overcurrent Device Location
(1) Wiring and Protection, System Bonding Jumper
system bonding jumper connection to the tie point of the grounded circuit conductors from each power source shall be permitted. Exception No. 2: If ...
National Electrical Code 2020 of Minnesota > 2 Wiring and Protection > 250 Grounding and Bonding > 250.30 Grounding Separately Derived Alternating-Current Systems > (A) Grounded Systems > (1) System Bonding Jumper