// CODE SNIPPET
2304.12.2.1 Girder Ends
Related Code Sections
2304.12.2.1 Wood, Girder Ends
The ends of wood girders entering exterior masonry or concrete walls shall be provided with a 1 / 2 -inch (12.7 mm) airspace on top, sides and end ...
Building Code 2018 of Illinois > 23 Wood > 2304 General Construction Requirements > 2304.12 Protection Against Decay and Termites > 2304.12.2 Other Locations > 2304.12.2.1 Girder Ends
1705.14.4.6 Special Inspections and Tests, Beams and Girders
At beams and girders thickness measurements shall be made at nine locations around the beam or girder at each end of a 12-inch (305 mm) length ...
Building Code 2018 of Illinois > 17 Special Inspections and Tests > 1705 Required Special Inspections and Tests > 1705.14 Sprayed Fire-Resistant Materials > 1705.14.4 Thickness > 1705.14.4.6 Beams and Girders
2207.2 Steel, Design
the specifications listed in Section 2207.1; and shall indicate the requirements for joist and joist girder design, layout, end supports, anchorage, bridging ...
2308.4.1 Wood, Girders
to support the loads specified in this code. Girder end joints shall occur over supports. Where a girder is spliced over a support, an adequate tie shall ...
Building Code 2018 of Illinois > 23 Wood > 2308 Conventional Light-Frame Construction > 2308.4 Floor Framing > 2308.4.1 Girders
1618.104.22.168 Structural Design, Beams
End connections of all beams and girders shall have a minimum nominal axial tensile strength equal to the required vertical shear strength ...
Building Code 2018 of Illinois > 16 Structural Design > 1616 Structural Integrity > 1616.2 Frame Structures > 1616.2.2 Structural Steel, Open Web Steel Joist or Joist Girder, or Composite Steel and Concrete Frame Structures > 1622.214.171.124 Beams