// CODE SNIPPET
908.2 Gas-Fired Clothes Dryers
JUMP TO FULL CODE CHAPTER
The installation of clothes dryers shall comply with the following requirements:
- Listed Type 1 clothes dryers shall be installed with a clearance of not less than 6 inches (152 mm) from adjacent combustible material. Clothes dryers listed for installation at reduced clearances shall be installed in accordance with their listing and the manufacturer's installation instructions. Type 1 clothes dryers installed in closets shall be listed for such installation.
- Listed Type 2 clothes dryers shall be installed with clearances of not less than that shown on the marking plate and in the manufacturer's instructions. Type 2 clothes dryers designed and marked, "For use only in noncombustible locations," shall not be installed elsewhere.
- Unlisted clothes dryers shall be installed with clearances to combustible material of not less than 18 inches (457 mm). Combustible floors under unlisted clothes dryers shall be protected in an approved manner.
Type 1 and Type 2 clothes dryers shall be exhausted to the outside air in accordance with Section 504.4.
Clothes dryers installed for multiple-family or public use shall be equipped with approved safety shutoff devices and shall be installed as specified for a Type 2 clothes dryer in accordance with Section 504.4.3.1. [NFPA 54:10.4.6]
Related Code Sections
908.2 Installation of Specific Appliances, Gas-Fired Clothes Dryers
Gas-fired clothes dryers shall comply with Section 908.2.1 through Section 908.2.3 ...
Uniform Mechanical Code 2018 of Nevada > 9 Installation of Specific Appliances > 908.0 Clothes Dryers > 908.2 Gas-Fired Clothes Dryers
504.4 Exhaust Systems, Clothes Dryers
A clothes dryer exhaust duct shall not be connected to a vent connector, gas vent, chimney, and shall not terminate into a crawl space, attic ...
Uniform Mechanical Code 2018 of Nevada > 5 Exhaust Systems > 504.0 Environmental Air Ducts > 504.4 Clothes Dryers
Section G2438 Fuel Gas, (613) Clothes Dryers
Clothes dryers shall be tested in accordance with ANSI Z21.5.1 and shall be installed in accordance with the manufacturer's installation ...
Section G2438 Fuel Gas, (613) Clothes Dryers
Clothes dryers shall be tested in accordance with ANSI Z21.5.1/CSA 7.1 and shall be installed in accordance with the manufacturer's instructions ...
Section G2439 Fuel Gas, (614) Clothes Dryer Exhaust
with this code . Fire dampers shall not be installed in clothes dryer exhaust duct systems ...