// CODE SNIPPET
R702.6.2 Furring Strips
JUMP TO FULL CODE CHAPTER
Where furring strips are used, they shall be 1 inch by 2 inches or 1 inch by 3 inches (25 mm by 51 mm or 25 mm by 76 mm), spaced a distance on center equal to the desired exposure, and shall be attached to the wall by nailing through other wall material into the studs.
Related Code Sections
R702.6.2 Wall Covering, Furring Strips
Where furring strips are used, they shall be 1 inch by 2 inches or 1 inch by 3 inches (25 mm by 51 mm or 25 mm by 76 mm), spaced a distance on center ...
Residential Code 2018 of Kansas > 7 Wall Covering > R702 Interior Covering > R702.6 Wood Shakes and Shingles > R702.6.2 Furring Strips
(D) Wiring Methods and Materials, Cables and Raceways Parallel to Framing Members and Furring Strips
, rafters, or studs, or is installed parallel to furring strips, the cable or raceway shall be installed and supported so that the nearest outside surface ...
National Electrical Code 2017 of Kansas > 3 Wiring Methods and Materials > 300 General Requirements for Wiring Methods and Materials > 300.4 Protection Against Physical Damage > (D) Cables and Raceways Parallel to Framing Members and Furring Strips
803.15.1.1 Interior Finishes, Furred Construction
If the interior finish material is applied to furring strips, the intervening spaces between such furring strips shall comply with one ...
Building Code 2018 of Kansas > 8 Interior Finishes > 803 Wall and Ceiling Finishes > 803.15 Application of Interior Finish Materials to Fire-Resistance-Rated or Noncombustible Building Elements > 803.15.1 Direct Attachment and Furred Construction > 803.15.1.1 Furred Construction
R703.6.1 Wall Covering, Application
overlaps in the membrane of not less than 2 inches (51 mm) and vertical overlaps of not less than 6 inches (152 mm). Where horizontal furring strips are used ...
Residential Code 2018 of Kansas > 7 Wall Covering > R703 Exterior Covering > R703.6 Wood Shakes and Shingles > R703.6.1 Application
2504.1.1 Gypsum Board, Gypsum Panel Products and Plaster, Wood Framing
Wood supports for lath, gypsum board or gypsum panel products, as well as wood stripping or furring, shall be not less than 2 inches (51 mm) nominal ...
Building Code 2018 of Kansas > 25 Gypsum Board, Gypsum Panel Products and Plaster > 2504 Vertical and Horizontal Assemblies > 2504.1 Scope > 2504.1.1 Wood Framing