// CODE SNIPPET
1926.403(i)(1)(iv) Front Working Space
JUMP TO FULL CODE CHAPTER
Where there are live parts normally exposed on the front of switchboards or motor control centers, the working space in front of such equipment shall not be less than 3 feet (914 mm).
Related Code Sections
1926.403(i)(1)(iv) Electrical, Front Working Space
Where there are live parts normally exposed on the front of switchboards or motor control centers, the working space in front of such equipment shall ...
OSHA 1926 Construction > K Electrical > 1926.403 General Requirements > 1926.403(i) 600 Volts, Nominal, or Less > 1926.403(i)(1) Working Space About Electric Equipment > 1926.403(i)(1)(iv) Front Working Space
1926.403 Electrical, General Requirements
to be grounded. Working space is not required in back of assemblies such as dead-front switchboards or motor control centers where there are no renewable ...
1926.403(j) Electrical, Over 600 Volts, Nominal
The minimum clear working space in front of electric equipment ...
OSHA 1926 Construction > K Electrical > 1926.403 General Requirements > 1926.403(j) Over 600 Volts, Nominal
1926.451(b)(1) Scaffolds,
Each platform on all working levels of scaffolds shall be fully planked or decked between the front uprights and the guardrail supports as follows ...
OSHA 1926 Construction > L Scaffolds > 1926.451 General Requirements > 1926.451(b) Scaffold Platform Construction > 1926.451(b)(1)
1926.57(h)(3)(ii) Occupational Health and Environmental Controls,
Unobstructed walkways shall not be less than 6 1/2 feet (1.976 m) high and shall be maintained clear of obstruction from any work location ...
OSHA 1926 Construction > D Occupational Health and Environmental Controls > 1926.57 Ventilation > 1926.57(h) Spray Finishing Operations > 1926.57(h)(3) Design and Construction of Spray Booths > 1926.57(h)(3)(ii)