// CODE SNIPPET
1006.0 Floor Drain Traps
Go To Full Code Chapter
1006.1 General
Floor drains shall connect into a trap so constructed that it can be readily cleaned and of a size to serve efficiently the purpose for which it is intended. The drain inlet shall be so located that it is in full view. Where subject to the reverse flow of sewage or liquid waste, such drains shall be equipped with an approved backwater valve.
Related Code Sections
1006.0 Traps and Interceptors, Floor Drain Traps
Floor drains shall connect into a trap so constructed that it can be readily cleaned and of a size to serve efficiently the purpose for which ...
P3201.2.1.4 Traps, Barrier-Type Trap Seal Protection Device
A barrier-type trap seal protection device shall protect the floor drain trap seal from evaporation. Barrier-type floor drain trap seal protection ...
B 101.5 Explanatory Notes on Combination Waste and Vent Systems, Trap Sizes
Trap sizes are required to be equivalent to the branches they serve (two pipe sizes larger than normal), and tailpieces between fixtures or floor ...
704.3 Sanitary Drainage, Commercial Sinks
between the floor drain waste connection and the fixture drain. The fixture and floor drain shall be trapped and vented in accordance with this code ...
B 101.6 Explanatory Notes on Combination Waste and Vent Systems, Layout Drawings
A floor drain normally requires a 2 inch (50 mm) trap and waste. On a combination waste and vent system, both trap ...