// CODE SNIPPET
410.68 Feeder and Branch-Circuit Conductors and Ballasts
Related Code Sections
410.68 Equipment for General Use, Feeder and Branch-Circuit Conductors and Ballasts
Feeder and branch-circuit conductors within 75 mm (3 in.) of a ballast, LED driver, power supply, or transformer shall have an insulation temperature ...
National Electrical Code 2020 of Minnesota > 4 Equipment for General Use > 410 Luminaires, Lampholders, and Lamps > 410.68 Feeder and Branch-Circuit Conductors and Ballasts
(B) Wiring Methods and Materials, Branch Circuits or Feeders
Type USE cable installed as underground feeder and branch circuit cable shall comply with Part II of Article 340. Exception: Single-conductor Type ...
National Electrical Code 2020 of Minnesota > 3 Wiring Methods and Materials > 338 Service-Entrance Cable: Types SE and USE > 338.10 Uses Permitted > (B) Branch Circuits or Feeders
240.100 Wiring and Protection, Feeders and Branch Circuits
Feeder and branch-circuit conductors shall have overcurrent protection in each ungrounded conductor located at the point where the conductor receives ...
National Electrical Code 2020 of Minnesota > 2 Wiring and Protection > 240 Overcurrent Protection > 240.100 Feeders and Branch Circuits
(B) Special Equipment, Feeder Conductors
The ampacity of conductors and the rating of overcurrent devices of a feeder for two or more branch circuits supplying X-ray units shall not be less ...
National Electrical Code 2020 of Minnesota > 6 Special Equipment > 660 X-Ray Equipment > 660.6 Rating of Supply Conductors and Overcurrent Protection > (B) Feeder Conductors
(2) Special Occupancies, Feeders
Note: The minimum conductor size for branch and feeder circuits is also governed by voltage regulation requirements. For a specific installation ...
National Electrical Code 2020 of Minnesota > 5 Special Occupancies > 517 Health Care Facilities > 517.73 Rating of Supply Conductors and Overcurrent Protection > (A) Diagnostic Equipment > (2) Feeders