// CODE SNIPPET
32.4.8 Electrical Requirements
JUMP TO FULL CODE CHAPTER
Electrical equipment shall be in accordance with Section 11.1. [140:4.8.1]
Soundstages and approved production facilities shall be provided with a minimum of 35 W/ft2 (377 W/m2) dedicated for production lighting and power. [140:4.8.2]
The electrical distribution equipment used shall comply with UL 1640, Standard for Portable Power-Distribution Equipment, and the provisions of Article 530 of NFPA 70. [140:4.8.3]
The wiring method to electrical distribution equipment shall comply with the provisions of Article 530 of NFPA 70. [140:4.8.4]
The location of portable, mobile, or stationary power-generating equipment shall be subject to the approval of the AHJ. [140:4.8.5]
Exterior penetrations shall be located near the predesignated location for portable and mobile power-generating equipment. [140:4.8.6]
Auxiliary power cables supplied from mobile generators or adjacent buildings shall not be routed through fire-rated windows and doors. [140:4.8.7]
Portable feeder cables shall be permitted to temporarily penetrate fire-rated walls, floors, or ceilings, provided that all of the following apply:
- The opening is of noncombustible material.
- When in use, the penetration is sealed with a temporary seal of a listed firestop material.
- When not in use, the opening shall be capped with a material of equivalent fire rating.
[140:4.8.8]
Where the penetration utilizes a conduit, metal-threaded caps shall be attached to the pipe by means of chain or cable and shall effectively cap the conduit when not in use. [140:4.8.9]
The lighting equipment used shall comply with UL 1573, Standard for Stage and Studio Luminaires and Connector Strips, and the provisions of Article 530 of NFPA 70. [140:4.8.10]
Related Code Sections
1006.8 Boilers, Water Heaters and Pressure Vessels, Electrical Requirements
The power supply to the electrical control system shall be from a two-wire branch circuit that has a grounded conductor, or from an isolation ...
Mechanical Code 2015 of West Virginia > 10 Boilers, Water Heaters and Pressure Vessels > 1006 Safety and Pressure Relief Valves and Controls > 1006.8 Electrical Requirements
306.3.1 General Regulations, Electrical Requirements
A luminaire controlled by a switch located at the required passageway opening and a receptacle outlet shall be provided at or near the appliance ...
Fuel Gas Code 2015 of West Virginia > 3 General Regulations > 306 (IFGC) Access and Service Space > 306.3 Appliances in Attics > 306.3.1 Electrical Requirements
306.3.1 General Regulations, Electrical Requirements
A luminaire controlled by a switch located at the required passageway opening and a receptacle outlet shall be provided at or near the appliance ...
Mechanical Code 2015 of West Virginia > 3 General Regulations > 306 Access and Service Space > 306.3 Appliances in Attics > 306.3.1 Electrical Requirements
32.4.8 Motion Picture and Television Production Studio Soundstages and Approved Production Facilities, Electrical Requirements
Electrical equipment shall be in accordance with Section 11.1. [ 140: 4.8.1 ...
Fire Code 2018 of West Virginia > 32 Motion Picture and Television Production Studio Soundstages and Approved Production Facilities > 32.4 Soundstages and Approved Production Facilities > 32.4.8 Electrical Requirements
32.5.8 Motion Picture and Television Production Studio Soundstages and Approved Production Facilities, Electrical Requirements
Electrical power connections made to the site electrical service shall be made by an approved electrician under permit from the AHJ. [ 140: 5.8.1 ...
Fire Code 2018 of West Virginia > 32 Motion Picture and Television Production Studio Soundstages and Approved Production Facilities > 32.5 Production Locations > 32.5.8 Electrical Requirements