// CODE SNIPPET
403.8 Dynamic Reset
JUMP TO FULL CODE CHAPTER
The system shall be permitted to be designed to reset the outdoor air intake flow (Vot), the space or ventilation zone airflow (Voz) as operating conditions change. [ASHRAE 62.1:6.2.7]
Related Code Sections
403.8 Ventilation Air, Dynamic Reset
The system shall be permitted to be designed to reset the outdoor air intake flow ( V ot ), the space or ventilation zone airflow ( V oz ...
2018 Uniform Mechanical Code of Nevada > 4 Ventilation Air > 403.0 Ventilation Rates > 403.8 Dynamic Reset
C3.5.5.2 Normative Appendix C Methodology for Building Envelope Trade-Off Option in Section 5.6, Dynamic Glazing
Automatically controlled dynamic glazing is allowed to be modeled. Manually controlled dynamic glazing shall use the average of the minimum ...
Energy Standard for Buildings Except Low-Rise Residential Buildings 2016 of Nevada > Normative Appendix C Methodology for Building Envelope Trade-Off Option in Section 5.6 > C3 Simulation General Requirements > C3.5 Calculation of Proposed Envelope Performance Factor > C3.5.5 Building Envelope > C3.5.5.2 Dynamic Glazing
C402.3.3.5 [CE] Commercial Energy Efficiency, Dynamic Glazing
For compliance with Section C402.3.3, the SHGC for dynamic glazing shall be determined using the manufacturer's lowest-rated SHGC, and the VT/SHGC ...
Energy Conservation Code 2012 of Nevada > 4 [CE] Commercial Energy Efficiency > C402 Building Envelope Requirements > C402.3 Fenestration (Prescriptive) > C402.3.3 Maximum U-factor and SHGC > C402.3.3.5 Dynamic Glazing
C402.4.3.3 [CE] Commercial Energy Efficiency, Dynamic Glazing
Where dynamic glazing is intended to satisfy the SHGC and VT requirements of Table C402.4, the ratio of the higher to lower labeled SHGC shall ...
Energy Conservation Code 2018 of Nevada > 4 [CE] Commercial Energy Efficiency > C402 Building Envelope Requirements > C402.4 Fenestration (Prescriptive) > C402.4.3 Maximum U-factor and SHGC > C402.4.3.3 Dynamic Glazing
(4) Equipment for General Use, Automatic Reset
Overload sensing devices shall not automatically reset after trip unless resetting of the overload sensing device does not cause automatic restarting ...
National Electrical Code 2017 of Nevada > 4 Equipment for General Use > 430 Motors, Motor Circuits, and Controllers > 430.225 Motor-Circuit Overcurrent Protection > (B) Overload Protection > (4) Automatic Reset