// CODE SNIPPET
Section 2114 Dry-Stack Masonry
JUMP TO FULL CODE CHAPTER
Dry-stack masonry shall be of adequate strength and proportions to support all superimposed loads without exceeding the allowable stresses listed in Table 2114.4. Allowable stresses not specified in Table 2114.4 shall comply with the requirements of Chapter 8 of TMS 402.
|DESCRIPTION||MAXIMUM ALLOWABLE STRESS (psi)|
For SI: 1 pound per square inch = 0.006895 MPa.
Related Code Sections
Section 2114 Masonry, Dry-Stack Masonry
The design of dry-stack masonry structures shall comply with the requirements of Chapters 1 through 8 of TMS 402 except as modified by Sections ...
2103.2 Masonry, Mortar
Mortar for masonry construction shall comply with Section 2103.2.1, 2103.2.2, 2103.2.3 or 2103.2.4 ...
2103.2.3 Masonry, Mortars for Ceramic Wall and Floor Tile
/ 5 hydrated lime; 4 dry or 5 damp sand Setting bed and leveling coat 1 cement; 1 / 2 hydrated lime; 5 damp sand to 1 cement 1 hydrated ...
Building Code 2018 of Illinois > 21 Masonry > 2103 Masonry Construction Materials > 2103.2 Mortar > 2103.2.3 Mortars for Ceramic Wall and Floor Tile
222.214.171.124 Masonry, Dry-Set Portland Cement Mortars
with ANSI A118.1. The shear bond strength for tile set in such mortar shall be as required in accordance with ANSI A118.1. Tile set in dry-set Portland ...
Building Code 2018 of Illinois > 21 Masonry > 2103 Masonry Construction Materials > 2103.2 Mortar > 2103.2.3 Mortars for Ceramic Wall and Floor Tile > 2126.96.36.199 Dry-Set Portland Cement Mortars
Section 2103 Masonry, Masonry Construction Materials
Concrete masonry units, clay or shale masonry units, stone masonry units, glass unit masonry and AAC masonry units shall comply with Article 2.3 ...