// CODE SNIPPET
404.2.9 Door Surface
JUMP TO FULL CODE CHAPTER
Door surfaces within 10 inches (255 mm) of the floor, measured vertically, shall be a smooth surface on the push side extending the full width of the door. Parts creating horizontal or vertical joints in such surface shall be within 1/16 inch (1.6 mm) of the same plane as the other. Cavities created by added kick plates shall be capped.
EXCEPTIONS:
- Sliding doors shall not be required to comply with Section 404.2.9.
- Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at no less than 60 degrees from the horizontal shall not be required to comply with the 10-inch (255 mm) bottom rail height requirement.
- Doors that do not extend to within 10 inches (255 mm) of the floor shall not be required to comply with Section 404.2.9.
Related Code Sections
404.2.9 Accessible Routes, Door Surface
Door surfaces within 10 inches (255 mm) of the floor, measured vertically, shall be a smooth surface on the push side extending the full width ...
Accessible and Usable Buildings and Facilities 2009 of New York State > 4 Accessible Routes > 404 Doors and Doorways > 404.2 Manual Doors > 404.2.9 Door Surface
5.6.1.11.5 Special Application Elevators, Setting of the Door
The door shall be set in the roof in such a manner that the upper surface of the rooftop door is at least 25 mm (1 in.) above the surface of the roof ...
Safety Code for Elevators and Escalators 2013 of New York State > 5 Special Application Elevators > 5.6 Rooftop Elevators > 5.6.1 Electric Rooftop Elevators > 5.6.1.11 Protection of Hoistway Landing Openings > 5.6.1.11.5 Setting of the Door
5.6.1.11.5 Special Application Elevators, Setting of the Door
The door shall be set in the roof in such a manner that the upper surface of the rooftop door is at least 25 mm (1 in.) above the surface of the roof ...
Safety Code for Elevators and Escalators 2016 of New York State > 5 Special Application Elevators > 5.6 Rooftop Elevators > 5.6.1 Electric Rooftop Elevators > 5.6.1.11 Protection of Hoistway Landing Openings > 5.6.1.11.5 Setting of the Door
2409.4.2 Glass and Glazing, Surface Area
The glass in glass elevator car doors shall be not less than 60 percent of the total visible door panel surface area as seen from the car side ...
2020 Building Code of New York State > 24 Glass and Glazing > 2409 Glass in Walkways, Elevator Hoistways and Elevator Cars > 2409.4 Glass in Elevator Cars > 2409.4.2 Surface Area
2409.4.2 Glass and Glazing, Surface Area
The glass in glass elevator car doors shall be not less than 60 percent of the total visible door panel surface area as seen from the car side ...
Building Code 2015 of New York State > 24 Glass and Glazing > 2409 Glass in Walkways, Elevator Hoistways and Elevator Cars > 2409.4 Glass in Elevator Cars > 2409.4.2 Surface Area