// CODE SNIPPET
1024.2.6.3 Door Frame Markings
JUMP TO FULL CODE CHAPTER
The top and sides of the door frame shall be marked with a solid and continuous 1 inch to 2 inch (25 mm to 51 mm) wide stripe. Where the door molding does not provide sufficient flat surface on which to locate the stripe, the stripe shall be permitted to be located on the wall surrounding the frame.
Related Code Sections
1024.2.6.3 Means of Egress, Door Frame Markings
The top and sides of the door frame shall be marked with a solid and continuous 1 inch to 2 inch (25 mm to 51 mm) wide stripe. Where the door molding ...
NYC Building Code 2014 > 10 Means of Egress > 1024 Luminous Egress Path Markings > 1024.2 Required Markings > 1024.2.6 Doors From Exit Enclosures > 1024.2.6.3 Door Frame Markings
Section S101 Supplementary Figures for Luminous Egress Path Markings, General
WITH DOOR FRAME MARKING FIGURE S101.1(9) DIRECTIONAL SIGNAGE FIGURE S101.1(10) NO-EXIT SIGNAGE FIGURE S101.1 ...
Reference Standard 6 Means of Egress [PDF] (page 4)
the minimum 16 in2 *(406 mm2) of photoluminescent material is maintained. 22.214.171.124 Door frame markings. The top and sides of the door frame of all ...
Reference Standard 6 Means of Egress [PDF] (page 3)
continue across the floor in front of all doors, except in front of those doors marked with door frame markings in accordance with 126.96.36.199 (see figs. 13 ...
7188.8.131.52 Fire-Resistance-Rated Construction, Smoke and Draft Control Door Labeling Requirements
rating label of the door. This marking shall indicate that the door and frame assembly are in compliance when listed or labeled gasketing is also ...
NYC Building Code 2008 > 7 Fire-Resistance-Rated Construction > 715 Opening Protectives > 715.3 Fire Door and Shutter Assemblies > 715.3.5 Labeled Protective Assemblies > 7184.108.40.206 Smoke and Draft Control Door Labeling Requirements