UpCodes logo
Go To Full Code Chapter
1910.217(d)(9)(i)
The employer shall establish a diesetting procedure that will insure compliance with paragraph (c) of this section.
1910.217(d)(9)(iii)
The employer shall provide die stops or other means to prevent losing control of the die while setting or removing dies in presses which are inclined.
1910.217(d)(9)(iv)
The employer shall provide and enforce the use of safety blocks for use whenever dies are being adjusted or repaired in the press.
1910.217(d)(9)(v)
The employer shall provide brushes, swabs, lubricating rolls, and automatic or manual pressure guns so that operators and diesetters shall not be required to reach into the point of operation or other hazard areas to lubricate material, punches or dies.
1910.217(d)(9)(ii)
The employer shall provide spring loaded turnover bars, for presses designed to accept such turnover bars.

Related Code Sections