// CODE SNIPPET
1910.217(h)(12) Die Setting and Work Set-Up
JUMP TO FULL CODE CHAPTER
Die setting on presses used in the PSDI mode shall be performed in accordance with paragraphs (d) and (h) of this section.
Following a die change, the safety distance, the proper application of supplemental safeguarding, and the slide counterbalance adjustment (if the press is equipped with a counterbalance) shall be checked and maintained by authorized persons whose qualifications include knowledge of the safety distance, supplemental safeguarding requirements, and the manufacturer's specifications for counterbalance adjustment. Adjustment of the location of the PSDI presence sensing device shall require use of a special tool available only to the authorized persons.
The PSDI mode shall not be used for die setting or set-up. An alternative manual cycle initiation and control means shall be supplied for use in die setting which meets the requirements of paragraph (b)(7) of this section.
Related Code Sections
1910.217(h)(12) Machinery and Machine Guarding, Die Setting and Work Set-Up
not be used for die setting or set-up. An alternative manual cycle initiation and control means shall be supplied for use in die setting which meets ...
OSHA 1910 General Industry > O Machinery and Machine Guarding > 1910.217 Mechanical Power Presses > 1910.217(h) Presence Sensing Device Initiation (PSDI) > 1910.217(h)(12) Die Setting and Work Set-Up
1910.211(d)(20) Machinery and Machine Guarding, Die Set
Die set means a tool holder held in alignment by guide posts and bushings and consisting of a lower shoe, an upper shoe or punch holder, and guide ...
OSHA 1910 General Industry > O Machinery and Machine Guarding > 1910.211 Definitions > 1910.211(d) > 1910.211(d)(20) Die Set
1910.217(d)(7) Machinery and Machine Guarding, Die Fastening
Provision shall be made in both the upper and lower shoes for securely mounting the die to the bolster and slide. Where clamp caps or setscrews ...
OSHA 1910 General Industry > O Machinery and Machine Guarding > 1910.217 Mechanical Power Presses > 1910.217(d) Design, Construction, Setting and Feeding of Dies > 1910.217(d)(7) Die Fastening
1910.217(d)(8) Machinery and Machine Guarding, Die Handling
Handling equipment attach points shall be provided on all dies requiring mechanical handling ...
OSHA 1910 General Industry > O Machinery and Machine Guarding > 1910.217 Mechanical Power Presses > 1910.217(d) Design, Construction, Setting and Feeding of Dies > 1910.217(d)(8) Die Handling
1910.217(d) Machinery and Machine Guarding, Design, Construction, Setting and Feeding of Dies
, and furnish and enforce the use of hand tools for freeing and removing stuck work or scrap pieces from the die, so that no employee ...
OSHA 1910 General Industry > O Machinery and Machine Guarding > 1910.217 Mechanical Power Presses > 1910.217(d) Design, Construction, Setting and Feeding of Dies