// CODE SNIPPET
625.17 Cords and Cables
JUMP TO FULL CODE CHAPTER
The cable for cord-connected equipment shall comply with all of the following:
- Be any of the types specified in 625.17(B)(1) or hard service cord, junior hard service cord, or portable power cable types in accordance with Table 400.4. Hard service cord, junior hard service cord, or portable power cable types shall be listed, as applicable, for exposure to oil and damp and wet locations.
- Have an ampacity as specified in Table 400.5(A)(1) or, for 8 AWG and larger, in the 60°C columns of Table 400.5(A)(2).
- Have an overall length as specified in either of the following:
- When the interrupting device of the personnel protection system specified in 625.22 is located within the enclosure of the supply equipment or charging system, the power-supply cord shall be not more than the length indicated in (i) or (ii):
- For portable equipment in accordance with 625.44(A), the power supply cord shall be not more than 300 mm (12 in.) long.
- For stationary equipment in accordance with 625.44(B), the power supply cord shall be not more than 1.8 m (6 ft) long and the equipment shall be installed at a height that prevents the power supply cord from contacting the floor when it is connected to the proper receptacle.
- When the interrupting device of the personnel protection system specified in 625.22 is located at the attachment plug, or within the first 300 mm (12 in.) of the power-supply cord, the overall cord length shall be not greater than 4.6 m (15 ft).
- When the interrupting device of the personnel protection system specified in 625.22 is located within the enclosure of the supply equipment or charging system, the power-supply cord shall be not more than the length indicated in (i) or (ii):
The output cable to the electric vehicle shall be one of the following:
- Listed Type EV, EVJ, EVE, EVJE, EVT, or EVJT flexible cable as specified in Table 400.4
- An integral part of listed electric vehicle supply equipment
Informational Note: For information and listing requirements for electric vehicle supply equipment, see UL 2594-2016, Standard for Electric Vehicle Supply Equipment, and UL 2202-2009, Standard for Electric Vehicle (EV) Charging System Equipment.
The overall usable length shall not exceed 7.5 m (25 ft) unless equipped with a cable management system that is part of the listed electric vehicle supply equipment.
For portable EVSE, the cord-exposed usable length shall be measured from the face of the attachment plug to the face of the electric vehicle connector.
Where the electric vehicle supply equipment is fastened in place, the usable length of the output cable shall be measured from the cable exit of the electric vehicle supply equipment to the face of the electric vehicle connector.
Other cabling systems that are integral parts of listed EVSE and are intended to interconnect pieces of equipment within an EVSE system using approved installation methods shall be permitted.
Related Code Sections
625.17 Special Equipment, Cords and Cables
The cable for cord-connected equipment shall comply with all of the following: Be any of the types specified in 625.17(B)(1) or hard service cord ...
National Electrical Code 2020 of Texas > 6 Special Equipment > 625 Electric Vehicle Power Transfer System > 625.17 Cords and Cables
(B) Wiring Methods and Materials, Cord and Cable Assemblies
Suitable cord and cable assemblies identified for extra-hard usage or hard usage and listed bus drop cable shall be permitted as branches from ...
National Electrical Code 2020 of Texas > 3 Wiring Methods and Materials > (2)Floors > 368.56 Branches From Busways > (B) Cord and Cable Assemblies
(C) Special Equipment, Flexible Cords and Cables
Flexible cords and cables shall comply with Article 400 and be identified as extra hard usage, rated for outdoor use, and water and sunlight ...
National Electrical Code 2020 of Texas > 6 Special Equipment > 600 Electric Signs and Outline Lighting > 600.34 Photovoltaic (PV) Powered Sign > (C) Flexible Cords and Cables
(3) Special Equipment, Flexible Cords and Cables
Flexible cords and cables that are components of listed equipment and used in circuits operating at 30 volts rms or less or 42 volts dc or less shall ...
National Electrical Code 2020 of Texas > 6 Special Equipment > 620 Elevators, Dumbwaiters, Escalators, Moving Walks, Platform Lifts, and Stairway Chairlifts > 620.21 Wiring Methods > (C) Platform Lifts and Stairway Chairlift Raceways > (3) Flexible Cords and Cables
(B) Special Equipment, Flexible Cords and Cables
Flexible cords and cables, where used to connect the moving parts of turbines or where used for ready removal for maintenance and repair, shall ...
National Electrical Code 2020 of Texas > 6 Special Equipment > 694 Wind Electric Systems > 694.30 Permitted Methods > (B) Flexible Cords and Cables