// CODE SNIPPET
2409.4.2 Control of Overchop
JUMP TO FULL CODE CHAPTER
In areas where chopper guns are used, exposed wall and floor surfaces shall be covered with paper, polyethylene film or other approved material to allow for removal of overchop. Overchop shall be allowed to cure for not less than 4 hours prior to removal.
Related Code Sections
2409.4.2 Flammable Finishes, Control of Overchop
to allow for removal of overchop. Overchop shall be allowed to cure for not less than 4 hours prior to removal ...
Fire Code 2018 of Kansas > 24 Flammable Finishes > 2409 Indoor Manufacturing of Reinforced Plastics > 2409.4 Housekeeping, Maintenance, Storage and Use of Hazardous Materials > 2409.4.2 Control of Overchop
1204.4.1 Interior Environment, Controls
The control for activation of the required stairway lighting shall be in accordance with NFPA 70 ...
Building Code 2018 of Kansas > 12 Interior Environment > 1204 Lighting > 1204.4 Stairway Illumination > 1204.4.1 Controls
2006.6.1 Aviation Facilities, Controls
Emergency fuel shutoff controls shall be provided with ready access at all times when the fueling system is being operated ...
Fire Code 2018 of Kansas > 20 Aviation Facilities > 2006 Aircraft Fueling > 2006.6 Emergency Fuel Shutoff > 2006.6.1 Controls
5003.3.1.3 Hazardous Materials—General Provisions, Control
Where an unauthorized discharge caused by primary container failure is discovered, the involved primary container shall be repaired or removed from ...
Fire Code 2018 of Kansas > 50 Hazardous Materials—General Provisions > 5003 General Requirements > 5003.3 Release of Hazardous Materials > 5003.3.1 Unauthorized Discharges > 5003.3.1.3 Control