// CODE SNIPPET
(C) Conductors Outside of an Enclosure or Operator Station
Related Code Sections
(C) Special Occupancies, Conductors Outside of an Enclosure or Operator Station
The size of conductors in a listed and jacketed, multiconductor cable shall not be smaller than 26 AWG. Single conductors shall not be smaller than ...
National Electrical Code 2020 of Minnesota > 5 Special Occupancies > 522 Control Systems for Permanent Amusement Attractions > 522.21 Conductor Sizing > (C) Conductors Outside of an Enclosure or Operator Station
(A) Communications Systems, Outside of Buildings
Lead-in conductors attached to buildings shall be installed so that they cannot swing closer than 600 mm (2 ft) to the conductors of circuits of 250 ...
National Electrical Code 2020 of Minnesota > 8 Communications Systems > 810 Radio and Television Equipment > 810.18 Clearances — Receiving Stations > (A) Outside of Buildings
(4) Equipment for General Use, Switching of Conductors
-enclosed switches shall be operable from outside the enclosure ...
National Electrical Code 2020 of Minnesota > 4 Equipment for General Use > 490 Equipment Over 1000 Volts, Nominal > 490.21 Circuit-Interrupting Devices > (E) Load Interrupters > (4) Switching of Conductors
(2) Wiring and Protection, Outside a Raceway or an Enclosure
If installed on the outside, the length of the bonding jumper or conductor or equipment bonding jumper shall not exceed 1.8 m (6 ft) and shall ...
National Electrical Code 2020 of Minnesota > 2 Wiring and Protection > 250 Grounding and Bonding > 250.102 Grounded Conductor, Bonding Conductors, and Jumpers > (E) Installation > (2) Outside a Raceway or an Enclosure
300.3 Wiring Methods and Materials, Conductors
conductors shall be permitted to be installed outside a raceway or cable assembly where in accordance with the provisions of 250.130(C) for certain existing ...
National Electrical Code 2020 of Minnesota > 3 Wiring Methods and Materials > 300 General Requirements for Wiring Methods and Materials > 300.3 Conductors