// CODE SNIPPET
C 107.0 Burner Operation
Go To Full Code Chapter
C 107.1 General
In making tests to determine compliance with the requirements of Section C 107.1, the following care shall be exercised to prevent the accumulation of unburned liquid fuel in the appliance that will result in an explosion or fire:
- The flames from the burner shall ignite freely the liquid fuel where operating at the lowest firing position.
- Burner flames shall not flash back where the liquid fuel is turned on or off by an automatic control mechanism.
- Main burner flames shall ignite freely from the pilot where the pilot flame is reduced to a minimum point that will actuate the pilot safety device.
- Where ignition is made in a normal manner, the flame will not flash outside the appliance.
- Burners shall not expel liquid fuel through air openings where operating at prevailing pressure.
- Burners shall have a liquid-fuel air mixture to ensure smooth ignition of the main burner.
Related Code Sections
C 107.0 Installation and Testing of Oil (Liquid) Fuel-Fired Equipment, Burner Operation
where operating at the lowest firing position.
Burner flames shall not flash back where the liquid fuel is turned on or off by an automatic control ...
506.8.2 Water Heaters, Motorized Louvers
burner operation. Means shall be provided to prevent the main burner from igniting should the louver fail to open during burner startup and to shut ...
701.10.2 Combustion Air, Motorized Louvers
burner operation. Means shall be provided to prevent the main burner from igniting where the louver fail to open during burner start-up and to shut ...
G2407.9.2 Fuel Gas, (304.9.2) Appliance Interlock
Each of the appliances served shall be interlocked with the mechanical air supply system to prevent main burner operation when the mechanical air ...
G2407.9.2 Fuel Gas, (304.9.2) Appliance Interlock
Each of the appliances served shall be interlocked with the mechanical air supply system to prevent main burner operation when the mechanical air ...