// CODE SNIPPET
(D) Bends in Conductors
Related Code Sections
(D) Special Equipment, Bends in Conductors
Sharp bends in insulated conductors shall be avoided ...
National Electrical Code 2020 of Minnesota > 6 Special Equipment > 600 Electric Signs and Outline Lighting > 600.32 Neon Secondary-Circuit Wiring, Over 1000 Volts, Nominal > (D) Bends in Conductors
300.34 Wiring Methods and Materials, Conductor Bending Radius
conductors, the minimum bending radius is 12 times the diameter of the individually shielded conductors or 7 times the overall diameter, whichever ...
National Electrical Code 2020 of Minnesota > 3 Wiring Methods and Materials > 300 General Requirements for Wiring Methods and Materials > 300.34 Conductor Bending Radius
(A) General, 1000 Volts, Nominal, or Less
Wire bending space for conductors operating at 1000 volts or less shall be provided in accordance with the requirements of 314.28 ...
National Electrical Code 2020 of Minnesota > 1 General > 110 Requirements for Electrical Installations > 110.74 Conductor Installation > (A) 1000 Volts, Nominal, or Less
(A) Equipment for General Use, Top and Bottom Wire-Bending Space
The enclosure for a panelboard shall have the top and bottom wire-bending space sized in accordance with Table 312.6(B) for the largest conductor ...
National Electrical Code 2020 of Minnesota > 4 Equipment for General Use > 408 Switchboards, Switchgear, and Panelboards > 408.55 Wire-Bending Space Within an Enclosure Containing a Panelboard > (A) Top and Bottom Wire-Bending Space
382.26 Wiring Methods and Materials, Bends
A bend that reduces the normal spacing between the conductors shall be covered with a cap to protect the assembly from physical damage ...
National Electrical Code 2020 of Minnesota > 3 Wiring Methods and Materials > 382 Nonmetallic Extensions > 382.26 Bends