// CODE SNIPPET
382.26 Bends
JUMP TO FULL CODE CHAPTER
A bend that reduces the normal spacing between the conductors shall be covered with a cap to protect the assembly from physical damage.
Concealable extensions shall be permitted to be folded back over themselves and flattened as required for installation.
Related Code Sections
26.6.3 Construction Documents and Inspection, Bending
(b) Field bending of reinforcement partially embedded in concrete shall not be permitted, except as shown in the construction documents or permitted ...
Building Code Requirements for Structural Concrete of Illinois > 26 Construction Documents and Inspection > 26.6 Reinforcement Materials and Construction Requirements > 26.6.3 Bending
26.6.3 Construction Documents and Inspection, Bending
Design information:
Nonstandard bend geometry ...
Building Code Requirements for Structural Concrete of Illinois > 26 Construction Documents and Inspection > 26.6 Reinforcement Materials and Construction Requirements > 26.6.3 Bending
326.26 Wiring Methods and Materials, Bends
A run of Type IGS cable between pull boxes or terminations shall not contain more than the equivalent of four quarter bends (360 degrees total ...
National Electrical Code 2017 of Illinois > 3 Wiring Methods and Materials > 326 Integrated Gas Spacer Cable: Type IGS > 326.26 Bends
326.26 Wiring Methods and Materials, Bends
A run of Type IGS cable between pull boxes or terminations shall not contain more than the equivalent of four quarter bends (360 degrees total ...
National Electrical Code 2020 of Illinois > 3 Wiring Methods and Materials > 326 Integrated Gas Spacer Cable: Type IGS > 326.26 Bends
360.24 Wiring Methods and Materials, Bends
When FMT is infrequently flexed in service after installation, the radii of bends measured to the inside of the bend shall not be less than specified ...
National Electrical Code 2020 of Illinois > 3 Wiring Methods and Materials > 360 Flexible Metallic Tubing: Type FMT > 360.24 Bends