// CODE SNIPPET
Related Code Sections
1907.3 Concrete, Bending
The bending of reinforcement shall comply with ACI 318, Section 7.3 ...
26.6.3 Construction Documents and Inspection, Bending
(b) Field bending of reinforcement partially embedded in concrete shall not be permitted, except as shown in the construction documents ...
Building Code Requirements for Structural Concrete of Alabama > 26 Construction Documents and Inspection > 26.6 Reinforcement Materials and Construction Requirements > 26.6.3 Bending
326.26 Wiring Methods and Materials, Bends
A run of Type IGS cable between pull boxes or terminations shall not contain more than the equivalent of four quarter bends (360 degrees total ...
National Electrical Code 2014 of Alabama > 3 Wiring Methods and Materials > 326 Integrated Gas Spacer Cable: Type IGS > 326.26 Bends
3403.6.11 Flammable and Combustible Liquids, Bends
Pipe and tubing shall be bent in accordance with ASME B31.9 ...
Fire Code 2009 of Alabama > 34 Flammable and Combustible Liquids > 3403 General Requirements > 3403.6 Piping Systems > 3403.6.11 Bends
360.24 Wiring Methods and Materials, Bends
When FMT is infrequently flexed in service after installation, the radii of bends measured to the inside of the bend shall not be less than specified ...
National Electrical Code 2014 of Alabama > 3 Wiring Methods and Materials > 360 Flexible Metallic Tubing: Type FMT > 360.24 Bends