1707.3 Attachment of Lateral Braces
Where ceiling joists or truss bottom chords are deeper than 6 inches (152 mm), an anchor block shall be installed in each space between ceiling members along the length of the lateral brace except for the space next to the gable end wall.
- An anchor block shall be installed in each space between attic-framing members along the length of the lateral brace except for the space next to the gable end wall.
- Anchor blocks shall be minimum 15/32-inch plywood, 7/16-inch OSB, or nominal 2-inch thick lumber #2 spruce-pine-fir or better.
- Anchor blocks shall have minimum wide face dimension equal to the attic-framing members at the location where the anchor block is installed. Anchor blocks shall extend between attic-framing members and butt against them or their truss plates with a maximum gap of 1/8 inch (3 mm).
- Anchor blocks shall be installed on lateral braces with their wide face on the narrow face of lateral braces. Anchor blocks shall be placed on lateral braces with their attic interior edge flush with the attic interior face of lateral braces. They are permitted to be placed on different edges of lateral braces.
Anchor blocks shall be fastened to lateral braces with a single row of 8d common nail, 10d common nails or #9 screws with minimum penetration into lateral braces equal to the thickness of the anchor block or 1 inch (25.4 mm) whichever is greater. The minimum number of fastener shall be the maximum that can be placed in a single row with minimum 23/4-inches (70 mm) distance between fasteners and 23/4-inches (70 mm) distance to ends of anchor blocks except that the number of fasteners need not exceed three per anchor block made of nominal 2-inch thick lumber. For nominal 2-inch thick lumber anchor blocks, the number of fasteners need not exceed three fasteners per anchor block.