// CODE SNIPPET
§3005-05 Assembly and Disassembly of Amusement Devices
JUMP TO FULL CODE CHAPTER
The assembly and disassembly of an amusement device must be performed by or under the direct supervision of the owner or amusement park operator in accordance with the manual.
(a) Installation. Parts must be properly aligned and may not be bent, distorted, cut or otherwise damaged to force a fit. Parts requiring lubrication must be lubricated in the course of assembly and as required during operation. Fastening and locking devices, such as bolts, cap screws, cotter pins and lock washers, must be installed where required for safe operation. Nuts must be drawn tight, cotter pins must be spread, and lock nuts firmly set. "R" pins must only be used in locations recommended by the manufacturer or a registered design professional. Immediate inspection of fastening devices must be conducted after assembly to make sure that they have been properly installed.
(b) Worn or damaged parts. Parts that are excessively worn or that have been materially damaged may not be used. Close visual inspection of parts must be conducted during assembly and disassembly to discover such wear or damage.
(c) Tools. Anyone engaged in the assembly or disassembly of amusement devices must use tools of proper size and design to enable the work to be performed in a proper manner. Broken, damaged and unsuitable tools may not be used.
Related Code Sections
Reference Standard 18 Elevators and Conveyors [PDF] (page 33)
be affixed to the device. *6.14 ASSEMBLY AND DISASSEMBLY. *6.14.1 The assembly and disassembly of an amusement device shall be done by or under ...
Reference Standard 18 Elevators and Conveyors [PDF] (page 34)
Reference Standard 18 * 6.14.7 The owner of an amusement device shall comply with the manufacturers construction manual for the assembly ...
Reference Standard 18 Elevators and Conveyors [PDF] (page 28)
are seasonably operated. 126.96.36.199 An amusement device which has been assembled and disassembled shall be inspected and tested as required by the Department after ...
Reference Standard 18 Elevators and Conveyors [PDF] (page 29)
structure shall be visually inspected. The inspection of the amusement device shall be in the disassembled configuration where possible, in order ...
Reference Standard 18 Elevators and Conveyors [PDF] (page 26)
6.7 6.8 6.9 6.10 6.11 6.12 6.13 *6.14 *6.15 Design Amusement Device Entry and Discharge Means of Access and Egress Emergency Brakes and Anti-Roll ...