// CODE SNIPPET
§40-11 Applications and Plans
JUMP TO FULL CODE CHAPTER
(a) Before commencing the installation of a gas-fueled space or water heater in a dwelling an application, as specified below must be filed in the borough office of the Department of Buildings where the installation is to be made, giving the address of the dwelling and all pertinent information required on the forms.
(b) Applications shall be accepted only where gas appliances will be connected to flues in existing brick chimneys, and where no other venting or other work is required to be done. They shall not be accepted for installation of gas-fueled heaters in sleeping rooms. Applications shall clearly state the type of appliance to be installed, the floors, apartments and rooms in which they are to be placed, including the number of rooms in the apartment and the occupancy of each room, whether sleeping room or otherwise. They shall describe the condition of the chimney flue to be used and state whether the draft is satisfactory. If a gas meter is to be installed its location shall be given.
(c) Where vent pipes are to be installed, or other work done in connection with the installation of gas-fueled heaters, an application shall be filed. It shall indicate the type of each such device, the floor on which, and the apartment and the occupancy of the room in which such appliance is to be installed, the material and dimensions of the vent pipe or flue, and the dimensions of the court or yard to which the exhaust vent will be carried. If a gas meter is to be installed, its location shall be shown. No plumbing specification sheet need be filed with such application.
(d) Application for permits to install gas-fueled space heaters and water heaters may be made separately or together on one application but each such application shall indicate that all apartments in the building will be provided with gas-fueled space and/or water heaters as the case may be. The location, type, make, and capacity of all such appliances previously installed or to be installed in a building shall be specified. If any of the appliances have been installed in multiple dwellings prior to December 9, 1955, which the owner desires to maintain, the necessary work to make them comply with these rules should be indicated.
(e) An application may be filed by the owner of the premises, or his architect, engineer, contractor, plumber or other agent. If the application is not filed by the owner, and owner's authorization form also shall be filed.
Related Code Sections
*§28-104.8.4.3 Administration, Notice to Occupants
Upon issuance of a permit for work containing a tenant protection plan, the owner shall (i) distribute a notice regarding such plan ...
NYC General Admin. Provisions 2014 > 1 Administration > 104 Construction Documents > §28-104.8 Applications > *§28-104.8.4 Tenant Protection Plan > *§28-104.8.4.3 Notice to Occupants
Article 16 Sprinkler Systems [PDF] (page 1)
to make all conditions clear. 2. It shall be unlawful to commence any sprinkler work required or voluntary, until the plans and application have been ...
107.8 Administration, Earthwork Plans
applicable, the plans shall also include underpinning details, soil information in accordance with Chapter 18, and a final grading plan representing the lot ...
106.7.1 Administration, Foundation Plans
Where applicable, the plans shall include underpinning details. In addition, there shall be a statement indicating the character and minimum class ...
NYC Building Code 2008 > 1 Administration > 106 Construction Documents > 106.7 Structural Plans > 106.7.1 Foundation Plans
1210.2.1 Hydronic Piping, Design
and plans shall be filed and the approval of the department obtained. The plans and application shall contain, but not be limited to, the following ...
NYC Mechanical Code 2008 > 12 Hydronic Piping > 1210 High-Pressure Steam Piping Systems > 1210.2 New Systems > 1210.2.1 Design