// CODE SNIPPET
1910.217(h)(3)(i) Air Valve and Air Pressure Supply/Control
JUMP TO FULL CODE CHAPTER
The requirements of paragraphs (b)(7)(xiii), (b)(7)(xiv), (b)(10), (b)(12) and (c)(5)(iii) of this section apply to the pneumatic systems of machines used in the PSDI mode.
The air supply for pneumatic clutch/brake control valves shall incorporate a filter, an air regulator, and, when necessary for proper operation, a lubricator.
The air pressure supply for clutch/brake valves on machines used in the PSDI mode shall be regulated to pressures less than or equal to the air pressure used when making the stop time measurements required by paragraph (h)(2)(ii) of this section.
Related Code Sections
1910.217(h)(3)(i) Machinery and Machine Guarding, Air Valve and Air Pressure Supply/Control
The air pressure supply for clutch/brake valves on machines used ...
OSHA 1910 General Industry > O Machinery and Machine Guarding > 1910.217 Mechanical Power Presses > 1910.217(h) Presence Sensing Device Initiation (PSDI) > 1910.217(h)(3) Pneumatic Systems > 1910.217(h)(3)(i) Air Valve and Air Pressure Supply/Control
1910.169(b)(3) Compressed Gas and Compressed Air Equipment, Gauges and Valves
Every air receiver shall be equipped with an indicating pressure gauge (so located as to be readily visible) and with one or more spring-loaded ...
OSHA 1910 General Industry > M Compressed Gas and Compressed Air Equipment > 1910.169 Air Receivers > 1910.169(b) Installation and Equipment Requirements > 1910.169(b)(3) Gauges and Valves
1910.430(b) Commercial Diving Operations, Air Compressor System
Compressors used to supply air to the diver shall be equipped with a volume tank with a check valve on the inlet side, a pressure gauge, a relief ...
OSHA 1910 General Industry > T Commercial Diving Operations > 1910.430 Equipment > 1910.430(b) Air Compressor System
1910.94(a)(6) Occupational Health and Environmental Control, Air Supply and Air Compressors
for supplied-air quality and use specified in 29 CFR 1910.134(i) ...
OSHA 1910 General Industry > G Occupational Health and Environmental Control > 1910.94 Ventilation > 1910.94(a) Abrasive Blasting > 1910.94(a)(6) Air Supply and Air Compressors
1910.169(b) Compressed Gas and Compressed Air Equipment, Installation and Equipment Requirements
A drain pipe and valve shall be installed at the lowest point of every air receiver to provide for the removal of accumulated oil ...
OSHA 1910 General Industry > M Compressed Gas and Compressed Air Equipment > 1910.169 Air Receivers > 1910.169(b) Installation and Equipment Requirements